Grass Valley PDR v.2.2 - Manual (Page 296)

Chapter 10 Using TimeDelay
278 Profile Family
5. Playback begins at the Delay Time specified. Once playback is complete,
click Stop (on the record panel) to end the recording.
NOTE: After recording, remove or update the start time.
Changing Playback Delay Time
Once playback begins, the Delay Time for Channel value cannot be edited
directly. There are two methods to add more playback delay time:
Pausing the Playback Panel
1. Click on Pause in the playback panel to freeze the video. TimeDelay
increases the delay time by the amount of time playback is paused.
2. Click Pause again to continue playback.
Changing the Timecode
1. Click within the timecode display counter in the playback panel. This
accesses the Go to Timecode dialog box.
NOTE: When using this feature, the jump to the new timecode may
not be clean. There may be some momentary still video.
2. Click in the Enter Timecode box. The Go To Timecode dialog box is
displayed.
Figure 146. Go To Timecode dialog box