Grass Valley Profile XP Aug 16 2004 - Manual (Page 104)

Chapter 3 Working with RAID Storage Using GVG Disk Utility
104 Profile XP System Guide 23 July 2004
Starting and Stopping disk initialization
Initializing the disk array aligns the physical disk drive heads and, where applicable, sets
the striping and parity across the disk drives in a newly created logical unit. It takes a
very long time to complete and is rarely needed. Initialize disk modules only when
instructed to do so by Grass Valley product support.
Checking and restoring default PFR500 RAID Controller settings
RAID Controller settings are checked every time the GVG Disk Utility is started. When
the Disk Utility starts, you may receive a warning message stating that current RAID
controller settings are not set to the defaults required by the current Profile XP software
or Fiber Channel SCSI software installed. If you do not receive the message, your
controller settings are correct.
To check and restore PFR500 RAID controller settings:
1. Start GVG Disk Utility, then perform one of the following steps:
- If you receive an “incorrect” RAID Controller settings message when GVG
Disk Utility opens, continue with step 2 which follows.
- If you do not receive an “incorrect” RAID Controller settings message when
GVG Disk Utility opens, your settings are correct.
2. In the “incorrect” settings message box, click OK to restore default settings.