Grass Valley Profile XP Aug 16 2004 - Manual (Page 97)

Loading RAID controller microcode: All models
23 July 2004 Profile XP System Guide 97
6. On 100% completion, perform one of the following steps:
• If PFR 600 or PFR 700 chassis with redundant controllers - The RAID
storage is ready for operation. Proceed to step 7.
• All other models - Power cycle the RAID controller chassis, then restart the
Profile XP Media Platform.
Refer to “System reboot procedure” on page 94.
NOTE: If your RAID chassis is part of an Open SAN, refer to the instructions in
the Open SAN Instruction Manual for power-off and power-on procedures.
7. It is recommended that you create labeling for the controller’s rear panel indicating
the current microcode version.
This completes the RAID controller firmware upgrade.