Yaskawa i80M Maintenance Manual - Manual (Page 152)

6.1
6.1.1
NC RACK
POWER SUPPLY UNIT (MODEL MODEL
MOUNTING SCREW
INDICATION LAMP
{
CONNECTOR
.
SCREW
SCREW
.0
M O U N T I N G
SCREW
INDICATION LAMP
{
CONNECTOR
s c R E w
Model CPS-12N Model
(1) R e m o v a l
(b)
Check that AC input power is not supplied [the
SOURCE indication lamp (green) of the power
supply unit is off], then pull out the
CN04,
and CN05 cables.
Loosen the mounting screws in the three positions
in the figure and the power unit
from the NC rack.
(2) Installation
( a )
( b )
( c )
Insert the power supply unit in line with the guide
of the NC rack.
Loosen the mounting screws in the three positions
in the figure.
Insert the CN03, CN04, and CN05 cables into the
original positions.
144