Yaskawa i80M Maintenance Manual User Manual
Page 166
Advertising
6.1
6.1.8
NC RACK (Cent’d)
MODEL JANCD-FC242
(2)
(a)
(b)
(c)
Removal
Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit
off], loosen the mounting screw in the figure,
and remove the module from the NC rack.
Installation
See the figure for the exterior of the module.
Check the model and REV number of the replacement t
module for consistency.
Check that the ROM number and label contents of
the replacement module are the same as those of the
module to be replaced.
Insert the module in line with the guide of the NC
rack and tighten mounting screw.
158
Advertising