Yaskawa i80M Maintenance Manual - Manual (Page 196)

6.2 MACHINE CONTROL STATION (Cent’d)
6.2.1.3 MODEL JANCD-FC903-1
MOUNTING SCREW
M O U N T I N G S C R E W
MOUNTING SCREW
MOUNTING SCREW
(1) Removal
( a ) Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit
is off], then pull out cables connected to CN21,
CN24, CN25, CN28, and CN29 of model
( b )
JANCD-FC903-1O
Loosen the mounting screws of model
and remove model JANCD-FC903 from
panel.
(2) Installation
See the figure for the exterior of the
( a )
( b )
( d )
Check the model and REV number of
module for consistency.
Check that the setting of is the
before replacement.
the control
module.
the replacement
same as that
Install model JAN on the control panel
according to the figure.
Insert all cables to the original positions.
188