Yaskawa i80M Maintenance Manual - Manual (Page 92)

4.2 TROUBLESHOOTING BY ALARM CODES (Cent’d)
●
S e t t i n g o f A p p l i c a b l e I n t e r f a c e
Set the data transmission baud rate, stop bit length,
and control code sending command specifications.
<Operation>
n
❑
Depress the key.
❑
Depress the job selection soft key.
— The 1/O verification job is selected.
❑
Depress the function soft key.
0
— Select the 1/O equipment setup function.
❑
Set parameters one after another interactively.
1/0 UNIT SET 0 1 2 3 4 5
IN OUT
UNIT RS-232C
PORT No.1
BAUD RATE 4800 9600
STOP BIT 2 BITS 1 BITS
BITS 8 BITS 7 BITS
PARITY OFF EVEN PARITY
ON OFF
RTS CNTRL OFF
PARITY 1S0 ON OFF
ME M STP LSK
PARAM
Fig. 4.7 Setting of Serial Interface
84