1 nc rack – Yaskawa i80M Maintenance Manual User Manual
Page 182
Advertising
6.1 NC RACK
(Cent’d)
6.1.16 MODEL JANCD-FC420
SCREW
I
I
i
I
I
( 1 ) Removal
(a) Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of
power unit
is off], then pull out the CN43 cable.
(b) Loosen the mounting screw in the figure and
remove the module from the NC rack.
(2) Installation
See the figure for the exterior of the module.
(b)
Check the model and REV number of the replacement
module for consistency.
Check that the
number and label contents of
the replacement module are the same as those of the
module to be replaced.
174
Advertising