Yaskawa G7 Modbus Communication - Manual (Page 52)

52
Parameters (Read/Write)
The following table lists user accessible parameters for the G7 drive.

The “Name” column contains the parameter name.

The “Address” column contains the register address in hexadecimal format. G7 drive registers are always referred to in hexadecimal
format.

If the parameter values are chosen from a list of possible values, the list of choices can be found in the “Data” column. Parameter
limits and a short description of the parameter function is contained in the “+/- Limits - Description” column.

The “During Run” column describes whether the parameter can be written to while the Run command is active.

“R” - the parameter is writable during Run.

Blank - the parameter is Read Only during Run.

The “Access” columns describe the accessibility and access level for a given control mode (see A1-01 for access levels and A1-02 for
control modes).

“A” - the parameter requires Advanced Access (A1-01 = 2)


“Q” - the parameter has Quick Access


Blank - the parameter is not accessible for that mode of operation
CAUTION
Read and understand the G7 Drive Technical Manual (TM.G7.01) and understand the ramifications of changing parameters via any network
communication interface. The parameter and associated values in the tables below are for information purposes only. Parameters not listed in the
tables below yet accessible via the digital operator must be changed via the digital operator. For information on a specific parameter and its
function, refer to the G7 Drive Technical Manual.