TA Triumph-Adler DCC 2930 - Manual (Page 412)

Default Setting (System Menu)
9-106
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network, [ ], [Next] of Secure Protocol, and then [Change] of SMTP Security.
3 Press [Off], [SSL/TLS] or [STARTTLS].
4 Press [OK].
POP3 Security (User 1)
Select the communication protocol according to the type of security employed by the POP3 server. The default
setting is Off.
The table below shows the available settings.
* You can change the port number using Embedded Web Server RX.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network, [ ], [Next] of Secure Protocol, and then [Change] of POP3 Security
(User 1).
3 Press [Off], [SSL/TLS] or [STARTTLS].
4 Press [OK].
POP3 Security (User 2)
Set the protocol that can be used on the POP3 port. This setup is available when SSL is On. The default setting
is Off.
For the procedure for selecting the POP3 Security (User 2) Setting, see POP3 Security (User 1).
Item Description
Off Do not use security employed by the POP3 server.
SSL/TLS Encryption is applied any data communication. To enable POP3 security, the
POP3 port may have to be changed according to the server settings.
Typically, 995* for SSL/TLS is well-known POP3 port.
STARTTLS Encryption is applied any data communication. Typically, 110* for
STARTTLS is well-known POP3 port.