TA Triumph-Adler DCC 2930 User Manual

Page 541

Advertising
background image

Appendix-5

Maximum number of sheets available for manual stapling

Use the buttons on the stapling control section of the Finisher (optional) for manual stapling.

1

Press the stapling position key on the stapling control section.
The shutter of the paper exit area is opened and this equipment enters into the manual staple mode.

2

Press the stapling position key to select the stapling position (Back

/ Front

/ 2 Points

).

Operation is not possible while the stapling position lamps are blinking. Operate after the lamps light solidly.

3

Straighten the edges of the paper well and place the paper

front side down in the shutter opening of the output unit.
If the near side of the paper (

) will be stapled, place the

paper against the front guide (A).
If the far side of the paper (

) will be stapled, place the paper

against the back guide (B).
If the edge of the paper (

) will be stapled at two points,

place the paper with the center aligned to the center point
between the two side guides (A and B).

CAUTION:

Do not insert your hand inside the open shutter.

NOTE:

Press the stapling position key before you place the paper. Once the paper is placed, the stapling

position key cannot be used.

The stapling lamp lights when the paper is properly placed. If it does not light, replace the paper.

4

Let go of the paper, and then press the stapling key.
Stapling starts. Stapling finishes and the output is delivered to tray A.

CAUTION:

Be sure that your hands are away from the paper while stapling is in progress.

Finishing the manual staple mode

Press the stapling position button several times until the stapling position lamps turn off. The shutter of the

paper exit area closes. It means that manual stapling is finished. If no operation is performed for approx. 10

seconds, the manual staple mode will be automatically finished.

NOTE:

The time after which manual staple mode is automatically exited can be changed. For details, refer to

Manual Staple on page 9-39

Paper size

Paper weight

- 90 g/m

2

( - 24.0 lb. Bond)

91 - 105 g/m

2

(24.3 - 28.0 lb. Bond)

A4, A4-R, B5, Letter, 16K

65 sheets

50 sheets

A3, B4, Folio

30 sheets

30 sheets

Stapling position

key

Stapling

key / lamp

Stapling position

lamps

A

B

Advertising
This manual is related to the following products: