TA Triumph-Adler DCC 2930 - Manual (Page 55)

Preparation before Use
2-9
2
Low Power Mode and Auto Low Power Mode
Low Power Mode
To activate Low Power Mode, press the Energy Saver
key. Touch panel and all indicators on the operation
panel will go out to save power except the Energy
Saver, Power, and main power indicators. This status
is referred to as Low Power Mode.
If print data is received during Low Power Mode, the
machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Low
Power Mode when using the optional fax, the machine
automatically wakes up and starts printing.
To resume, perform one of the following actions. The
30/30 ppm or 35/35 ppm model will be ready to operate
within 15 seconds, or the 45/45 ppm or 55/50 ppm
model will be ready within 20 seconds.
• Press any key on the operation panel.
• Open the platen cover or the optional document
processor.
• Place originals in the optional document processor.
Note that ambient environmental conditions, such as
ventilation, may cause the machine to respond more
slowly.
Auto Low Power Mode
Auto Low Power Mode automatically switches the machine into Low Power Mode if left idle for a preset time.
The default preset time is 3 minutes (for the 30/30 ppm, 35/35 ppm, or 45/45 ppm model) or 5 minutes (for the
55/50 ppm model).