TA Triumph-Adler P-4035 MFP - Manual (Page 171)

8-7
Fax Settings > Default fax settings
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
For details, refer to Transmission Restriction on page 8-9 .
Select Key Set. (Select Key Settings)
If you register a function to the Left Select key or Right Select key, you can quickly set the function when using fax
functions.
Dest. Entry(FAX) (New Destination Entry (FAX))
Duplex Printing When received multiple pages of data are the same width, they can be printed out on both
sides of paper having the same width as the data.
Value : On, Off
For details, refer to Duplex Printing on page 4-9 .
ECM RX Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
RX Start Speed Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item Description
Left You can register one of the following functions to each key.
Value : None, Quiet Mode, Original Size, Original Image, FAX Resolution, Orig.Orientation,
Continuous Scan, File Name Entry, JobFinish Notice, FAX Delayed TX, FAX Direct TX, FAX RX
Polling, FAX TX Report, Density, Duplex
NOTE
[FAX TX Report] is displayed when [FAX TX Result] is set to [Specify Each Job].
For details, refer to Send Result Reports (Send Result) on page 7-5 .
Right
Item Description
Dest. Entry(FAX) Select whether to permit direct entry of destination. When this option is set to [Prohibit], you
cannot enter the destination directly.
Value : Permit, Prohibit
Item Description