Command line interface, 1 accessing the cli, Logon to the console – PLANET WGSW-28040P User Manual
Page 218
User’s Manual of WGSW-28040 / 28040P / 28040P4
218
5. COMMAND LINE INTERFACE
5.1 Accessing the CLI
When accessing the management interface for the switch over a direct connection to the server’s console port, or via a Telnet
connection, the switch can be managed by entering command keywords and parameters at the prompt. Using the switch's
command-line interface (CLI) is very similar to entering commands on a UNIX system.
This chapter describes how to use the Command Line Interface (CLI).
Logon to the Console
Once the terminal has connected to the device, power on the WGSW Managed Switch, the terminal will display that it is running
testing procedures.
Then, the following message asks the login username & password. The factory default password as following and the login
screen in
Figure 5-1
appears.
Username: admin
Password: admin
1.
On ”Username” & ”Password”prompt, enter “admin”.
2.
On ”WGSW-28040>” prompt, enter “enable”.
3.
On ”Username” & ”Password”prompt, enter “admin”.
Figure 5-1 WGSW Managed Switch Console Login screen