ProSoft Technology ILX69-PBM - Manual (Page 13)

ILX69-PBM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Master Communication Module User Manual
ProSoft Technology, Inc. Page 13 of 124
February 4, 2015
2.4.1 Device Destruction if ILX69-PBM is Installed to Powered PLC
To avoid device destruction when the ILX69-PBM is powered up:
 Strictly obey to all safety rules provided by the PLC device manufacturer documentation.
 Shut off the power supply of the PLC, before you install the ILX69-PBM module.
2.4.2 Device Destruction by Exceeding Allowed Supply Voltage
To avoid device destruction due to high supply voltage to the ILX69-PBM, you must observe
the following instructions.
 The ILX69-PBM may only be operated with the specified supply voltage. Make sure that
the limits of the allowed range for the supply voltage are not exceeded.
 A supply voltage above the upper limit can cause severe damage to the ILX69-PBM.
 A supply voltage below the lower limit can cause malfunction in the ILX69-PBM.
 The allowed range for the supply voltage is defined by the tolerances specified in this
manual.
Mandatory supply voltage information is located at Power Supply (page 21).
2.4.3 Device Destruction by Exceeding Allowed Signaling Voltage
To avoid device destruction due to high signal voltage to the ILX69-PBM, you must observe
the following instructions.
 All I/O signal pins at the ILX69-PBM tolerate only the specified signaling voltage.
 Operation of the ILX69-PBM with a signaling voltage other than the specified signaling
voltage may lead to severe damage to the module.
Mandatory signaling voltage information is located at Power Supply (page 21).
2.4.4 Electrostatically sensitive devices
This equipment is sensitive to electrostatic discharge, which can cause internal damage and
affect normal operation. Therefore, adhere to the necessary safety precautions for
components that are vulnerable with electrostatic discharge when handling the ILX69-PBM.
Follow the guidelines listed when you handle this equipment:
 Touch a grounded object to discharge potential static.
 Wear an approved grounding wrist strap.
 Do not touch connectors or pins on the ILX69-PBM.
 Do not touch circuit components inside the equipment.
 If available, use a static-safe workstation.
 When not in use, store the equipment in appropriate static-safe packaging.
More information is located at Safety References (page 15).