ProSoft Technology ILX69-PBM - Manual (Page 88)

Contents ILX69-PBM ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS Master Communication Module
Page 88 of 124 ProSoft Technology, Inc.
February 4, 2015
6.3.4 CIP Message Error Codes
This section includes error codes and conditions that can occur when using CIP messages.
Your application can be constructed in a manner in which it catches the two possible error
cases:
 CIP Message instruction failure
 The requested command returns an error in its request confirmation
General CIP Message Error Codes
Below are general CIP Message error codes.
Note: Some CIP error codes are public and can also be generated by the
controller.
CIP
Status Extended
Status Meaning Cause Help
02 hex 00CA hex Resources unavailable
Out of segments System has no
segments left to
execute the command
02 hex 03E8 hex Resources unavailable
Out of CIP com buffer System has no CIP
communication buffer
left to execute the
command Check the number of parallel
CIP messages sent to the
module. The module can
process 5 CIP messages in
parallel. Note that RSLinx
can already consume 2 of
these CIP com buffers if the
online browser is active.
02 hex 0519 hex Resources unavailable
Out of command buffer System has no
command buffer left to
execute the command Contact technical support
08 hex 0000 hex Service not supported The service code of the
requested object is not
supported Check parameter of the CIP
Message
14 hex 0000 hex Attribute not supported The attribute of the
requested object is not
supported Check parameter of the CIP
Message
13 hex 0000 hex Insufficient data Too little data was
transferred with the
CIP Message Check the "Source Length"
parameter of the CIP
Message and check the
consistency of all length
parameters within the
requested command.