ProSoft Technology ILX69-PBM - Manual (Page 83)

ILX69-PBM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Master Communication Module User Manual
ProSoft Technology, Inc. Page 83 of 124
February 4, 2015
Slave Diagnostic
The Slave Diagnostic request is used to query the status of a slave by its address. This
request can be used to determine the general health of the slave device. The instruction
Request / Confirmation format is as follows.
ILX69PBM.CONTROL.SlaveDiagnostic.GetSlaveDiag.
Parameter Data Type Value Description
Initiate BOOL 0x0000 Triggers the Get Slave Diagnostic command
Address SINT 0 to 125 Slave address
Function SINT 0 or 1 0 = Requested from Master
1 = Requested from Slave
MSGStatus - - Message Status, see below
MSGStatus - Message Status
Parameter Data Type Description
Done BOOL Message Status is available
Error BOOL Last message was transmitted with an error
DoneCount DINT OK response count
ErrorCount DINT Error message count
ILX69PBM.CONTROL.SlaveDiagnostic.GetSlaveDiag.Response.
Name Data Type Description
SlaveAddress SINT Slave address
SlaveDiagnosticFailure SINT Slave Diagnostic Failure
StationNotExist BOOL No response from slave or the station does not exist.
StationNotReady BOOL Slave is not in a ready state
ConfigurationFault BOOL Configuration fault detected
ExtendedDiagnostic BOOL Extended diagnostics area is used
SyncFreezeNoSupport BOOL Unknown command is detected by the slave
InvalidResponse BOOL Invalid slave response
ParamterFault BOOL Last parameterization telegram was faulty
MasterLock BOOL Slave is controlled by another master
ParameterRequest BOOL Slave must be parameterized
StaticDiagnostic BOOL This bit remains active until all diagnostics data has been
retrieved from the slave
Slave BOOL This bit is always set by the slave
Watchdog BOOL Slave watchdog is activated
FreezeMode BOOL Freeze command active
SyncMode BOOL Sync command active
Reserved BOOL Reserved