ProSoft Technology MVI56E-DNPNET - Manual (Page 70)

Contents MVI56E-DNPNET ♦ ControlLogix Platform
User Manual DNPNET Ethernet Client/Server Communication Module
Page 70 of 140 ProSoft Technology, Inc.
February 13, 2015
3.7 Communication Error Codes
3.7.1 General Command Errors
Error
Code Name Description
1 Device not defined The IED slave address referenced in the
command is not defined in the module. Check
to make sure there is an entry in the slave
table for each slave device referenced in the
command list.
2 Invalid command This command is not valid. Check to make
sure the slave address parameter is greater
than or equal to zero and that the point count
is not set to zero.
3 Object not supported The data object in the command is not
supported by the module. Refer to the DNP
subset for the Master Port.
4 Command function not supported The function specified in the command is not
supported for the object type selected. Refer to
the DNP subset for the Master Port.
5 Command variation not supported The variation specified in the command is not
supported for the object type selected.
6 Object 10 not enabled The command is not supported unless Binary
Output Status is enabled
7 Object 40 not enabled The command is not supported unless Analog
Output Status is enabled
8 Invalid time/date poll command This time/date object poll command is not
valid.
9 Time/date poll command cannot
execute
This time/date object poll command cannot
execute because the module's clock has not
been synced from a valid source (from PLC or
connected Client)