Atlas Sound Atmosphere C-ZSV Zone, Source, and Volume Wall Controller (Black) - Manual (Page 17)

Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
[email protected]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 17 –
RCA Inputs - Mono
1. Displays rear panel and identifies physical location of the RCA mono-summed input for wiring. Navigation tabs for Gate, De-Esser, Compressor,
Equalizer, and Auto-Gain. (same as Mic/Line).
2. Shows input type and port select, “Change Type or Ports” to re-configure if desired.
3. Pre-set High Pass Filter Enable – a separate EQ filter placed before the Equalizer page allowing roll-off of low end before the gate and compressor,
allowing all bands of the equalizer to be used for other requirements.
4. 0dB to +30 dB of preamp gain available to fine tune RCA input sensitivity sources.
5. When in the General Settings page, editing of the source name, color tag (click on color), and also delete source “X”, is available.
Stereo Sources
Mic/Line - Stereo
1. Mic/Line Stereo sources require selecting a Left and Right input port which can be any available Mic/Line Inputs.
2. Pre-set High Pass Filter Enable for Left & Right – a separate EQ filter placed before the Equalizer page allowing roll-off of low end before the gate
and compressor, allowing all bands of the equalizer to be used for other requirements. NOTE: In Stereo Mode, the DSP will affect both left & right
channels automatically.
3. 0dB to +60 dB of preamp gain available to fine tune input sensitivity.
4. When in the General Settings page, editing of the source name, color tag (click on color), and also delete source “X”, is available.