Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor User Manual
Page 106
106
English
[SNMP v3] [USER]
[USER NAME]:
Enter the user name of SNMP v3.
[PERMISSION]:
Select whether to obtain only information via SNMP
v3 or to both obtain information and make the
setting.
[
SECURITY LEVEL
]:
Select the security level for SNMP v3.
[AUTHENTICATION PROTOCOL]:
Select the authentication method for SNMP v3 from
SHA1 and MD5.
[AUTHENTICATION PASSWORD]:
Set the authentication password of SNMP v3.
[
PRIVACY PROTOCOL
]:
Select the encryption method for SNMP v3 from
AES and DES.
[
PRIVACY PASSWORD
]:
Set the encryption password of SNMP v3.
[TRAP SETTINGS]
[TRAP]:
Select the SNMP version to use when sending
TRAP.
[COMMUNITY/USER]:
Select COMMUNITY/USER to use when sending
TRAP.
When SNMP v1/v2c is selected as a SNMP version
of TRAP, the COMMUNITY 1/2 setting is used.
When SNMP v3 is selected, the USER1/2 setting
is used.
[TRAP ADDRESS]
[ADDRESS]:
Set the IP address of the SNMP manager that gives
notice of TRAP.
[PORT]:
Set the TRAP reception port number of the SNMP
manager that gives notice of TRAP.
[TRAP OPTIONS]
[POWER]:
TRAP is sent if the unit enters the standby mode by
“Power management”, [No signal power off] or [No
activity power off].
[NO SIGNAL]:
TRAP is sent if no-signal continues in the following
conditions.
When set to [ENABLE(5min)]:
TRAP is sent if no-signal continues for 5 minutes.
When set to [ENABLE(No signal error timing)]:
TRAP is sent if no-signal error set with [Setup] –
[Information timing] occurs. (see page 88)
[TEMPERTURE]:
TRAP is sent if the temperature error occurs.
[AUTHENTICATION]:
TRAP is sent if the SNMP authentication fails.
[FATAL SHUTDOWN]:
TRAP is sent if a fatal error that requires the power
to be forcibly turned off occurs. However, all the fatal
errors do not necessarily support TRAP.
Note
●
The maximum number of characters that can be
used for a community name is 32 with one-byte
alphanumeric characters.
●
The maximum number of characters that can be used
for a user name and password is 32 with one-byte
alphanumeric characters.
Note that the password must be set with 8 characters
or more.
●
Change the password periodically, and set one which
is difficult to guess.
●
The SNMP manager must be operating in the system
configuration used.
●
For MIB (Management Information Base) of this unit,
see the web site below.
https://panasonic.net/cns/prodisplays
●
For the settings of the SNMP manager, consult with
the network administrator.