Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor - Manual (Page 81)

81
English
■
[Extron XTP]
Set to [On] when connecting XTP Transmitter made by
Extron to DIGITAL LINK terminal.
● For more details on Extron, visit the following web
site.
http://www.extron.com
■
[USB memory network settings]
Sets whether to permit the network setting using the
USB memory device. (see page 134)
[Permit]:
Permits USB memory network settings.
[Prohibit]:
Prohibits USB memory network settings.
Note
● This function is set to [Permit] as factory default.
● Once the network setting is done with USB memory
device, this function is set to [Prohibit].
■
[LAN control protocol]
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
● For PJLink and WEB browser control, the operation is
possible regardless of the setting.
● When operating the “Multi Monitoring & Control
Software”, select [Protocol 2].
■
[Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with and press <ENTER>.
Network settings
Reset
Yes No
Note
● The settings for [NTP synchronization], NTP server
and [Time zone] will be reset to the factory default.
USB media player settings
Set for “USB media player”.
For details of the function, refer to “USB media player”
(see page 111).
[USB media player settings] - submenu screen
USB media player settings
USB media player
Scenario file check
No scenario file
Slide show duration
Enable
10 sec
Schedule play function Enable
Video playback mode Standard
Schedule play function default setting
Play mode
Individual play
Current setting Individual play
Playlist edit
Still picture rotation Landscape
Resume play On
Codec information
■
[USB media player]
Set to enable or disable the USB media player function.
■
[Schedule play function]
Enables/Disables the schedule playback function using
“Content Management Software”.
Note
● When [Schedule play function] is set to [Enable],
if both the scenario file of the existing “USB media
player” and the schedule file of this function are
present, the [Schedule play function] operation takes
priority.
● [USB media player] cannot be changed during the
schedule playback mode.
● When this function is set to [Enable], set [Quick start]
to [On] to enable the operation.
● When [Quick start] is set to [Off], the unit enters the
standby state according to the schedule even if it is
set to [Enable]. However, the unit does not start up.
To operate the Schedule play function, it is necessary
to set [Quick start] to [On] and [Schedule play
function] to [Enable].
■
[ Video playback mode ]
Sets the video playback mode.
If image disturbance occurs at the switching timing of
motion picture files during playback in [Standard] mode,
switch to [Adjust] mode.
[Standard]: Plays without a black image at the joint
between video files.
[Adjust]: Plays with a black image (approx.
2 seconds) inserted at the joint between
video files.
Note
● When using the Multi Media Player, a black screen is
displayed for a certain period of time at the switching
timing of motion picture files regardless of the [Video
playback mode] settings.