Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor - Manual (Page 89)

89
English
Note
● When [SLOT standby] is set to [On], the power
indicator in standby mode lights orange (red/green).
● When [HDMI-CEC control] is set to [Enable], this
menu will be greyed out and cannot be set. (see page
72)
■
[SLOT power on]
Starts up the power of the SLOT.
■
[SLOT forced termination]
Forcibly turns off the power of the SLOT. Use this only
when the power cannot be turned off manually due to
the problem of the operating system, etc.
Maximum VOL function
Enables/Disables [Maximum VOL function].
[Off]:
The sound volume level can be set up to 100
(maximum).
[On]:
The volume cannot be set to the level higher than
the level set for [Maximum VOL level].
Maximum VOL level
Sets the sound volume when [Maximum VOL function]
is enabled.
Note
● Outputs with the set volume when [Maximum VOL
level] in [On] state is selected on the menu.
● When the [Maximum VOL function] is switched from
[Off] to [On], if the [Maximum VOL level] is set lower
than the [Initial VOL level], the [Initial VOL level]
automatically becomes the same as the [Maximum
VOL level].
Button lock
Limits operation of the buttons on the unit.
[Off]:
All the buttons on main unit can be used.
[On]:
All button operations except for the <Main Power
On / Off button> are disabled.
[MENU & ENTER]:
Locks <MENU (Unit)> and <ENTER (Unit)>
buttons.
■
To set [Button lock]
Set with the buttons on the unit.
[Off]:
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)>.
[On]:
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <ENTER (Unit)>.
[MENU & ENTER]:
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <ENTER (Unit)>.
Note
● About how to reset the settings to defaults, refer to
“Initialization”. (see page 142)
POWER button lock
Sets the lock setting for the display <Main Power On /
Off button>.
[Off]:
<Main Power On / Off button> operation is
enabled.
[On]:
<Main Power On / Off button> operation is
disabled.
Controller user level
Limits operation of the buttons on the remote control.
[Off]:
You can use all of the buttons on the remote
control.
[User1]:
You can only use <Standby (ON/OFF) button>,
<INPUT>, <RECALL>, <MUTE>, <VOL +> and
<VOL -> buttons on the remote control.
[User2]:
You can only use <Standby (ON/OFF) button> on
the remote control.
[User3]:
Locks all the buttons on the remote control.
Note
● About how to reset the settings to defaults, refer to
“Initialization”. (see page 142)