Network environment (multi media player only), Starting / ending media player – Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor User Manual

Page 117

Advertising
background image

117

English

Network environment (Multi Media

Player only)

Example of setting up LAN connection and

IP address / Subnet mask

As mentioned below, connect several units together with

LAN cables and set up IP addresses / Subnet masks so

that all the displays exist on the same network.

Parent

IP address:

Subnet mask:

192.168.10.1
255.255.255.0

Child

IP address:

Subnet mask:

192.168.10.2
255.255.255.0

Child

IP address:

Subnet mask:

192.168.10.3
255.255.255.0

Child

IP address:

Subnet mask:

192.168.10.4
255.255.255.0

Note

Set [Network control] of all displays to [On]. (see page

77)

Depending on the network environment,

synchronization may be largely lost.

Do not connect other devices to prevent network

traffic jam.

With a router put in between the displays, you cannot

set up connection. Use them within the same subnet.

Do not use wireless LAN for connection since

playback may not be performed normally.

Starting / ending Media Player

Note

Select the USB terminal to be used with [USB select].

(see page 90)

Depending on the USB terminal, the amount of

electricity supplied to an external device differs.

(“USB terminal connection”, see page 30)

For Single Media Player

Start
1. Insert the USB memory device for Media Player

to the USB terminal on the bottom of the display.

Note

Depending on the type of a USB memory device,

it may come in contact with the periphery such as

a back cover, and cannot be attached. Use a USB

memory device connectable to this unit.

USB

memory

USB terminal

2. Run a USB memory contents check.
3. Change INPUT to [USB].

Ending
Change INPUT to other than [USB].

For Multi Media Player

Start
1. Connect several units with LAN cables.

(See “Example of setting up LAN connection and IP

address / Subnet mask” in the previous section.)

2. Insert USB memory for Media Player into each

Display.

3. Executes USB memory contents check on each

Display.

4. Change INPUT for Child to [USB].
5. Change INPUT for Parent to [USB].

Ending
Change INPUT for Parent to other than [USB].

Advertising
This manual is related to the following products: