Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor - Manual (Page 24)

24
English
Pin assignments and signal names for DVI-D Input/
Output
Pin No. Signal Name
T.M.D.S. data 2 -
T.M.D.S. data 2 +
T.M.D.S. data 2 shield
DDC clock
DDC data
T.M.D.S. data 1 -
T.M.D.S. data 1 +
T.M.D.S. data 1 shield
+5 V DC
GND (Ground)
Hot plug detect
T.M.D.S. data 0 -
T.M.D.S. data 0 +
T.M.D.S. data 0 shield
T.M.D.S. clock shield
T.M.D.S. clock +
T.M.D.S. clock -
PC IN terminal connection
Connect a cable
which matches
the audio output
terminal on the
computer.
(commercially
available)
(Female) (Male)
Mini D-sub 15p cable (commercially available)
Stereo mini plug (M3) cable (commercially available)
PC
The type of computer signal that can be connected
● With regard to the typical PC input signals that
are described in “Preset Signals” (see page 138),
adjustment values such as for the standard picture
positions and sizes have already been stored in this
unit.
(Computer signals which can be input are those with
a horizontal scanning frequency of 30 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz.)
● The display resolution is a maximum of 1 440 x
1 080 dots when the aspect mode is set to [Normal],
and 1 920 x 1 080 dots when the aspect mode is
set to [Full]. If the display resolution exceeds these
maximums, it may not be possible to show fine detail
with sufficient clarity.
● If signals outside the range of supported frequencies
are input, normal images cannot be displayed. Note
that some images may not be correctly displayed
even if signals are within the range.
● If the PC screen is not displayed, check if the image
signal of the PC meets “Preset Signals” (see page
138), and then change the settings. For power-saving
purpose, image output may be OFF on a notebook
computer. In this case, it may be set to ON with
function key operation etc. of the computer. (Refer to
the manual of the computer.)