Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor - Manual (Page 64)

64
English
Input search
When a signal is not detected, another input with a
signal is automatically selected.
Note
● MEMORY VIEWER / Screen Transfer input is
excluded from this function.
Input search
Input search
1st search input
2nd search input
Custom
(None)
(None)
■
[Input search]
[Off]: When there is no signal, the input is
not switched automatically.
[All
inputs]:
Searches all inputs and switches to an
input with a signal.
Input search is executed in the
following order.
Example: When the current input is
HDMI1
[HDMI2 ] → [ DisplayPort ] → [ DIGITAL
LINK ] → [DVI-D ] (or [SLOT ]) → [ PC]
→ [ USB ] → [ HDMI1 ] →
Note
● The inputs set to [(Skip)] in [Input label] (see page 69)
are skipped when searching.
[Custom]: Repeatedly searches [Current input],
[1st search input] and [2nd search
input] in order, and switches to an input
with a signal.
[Input
detection]:
Monitors the inputs set to [On], detect
the status change from no signal to
signal present, and switches to the
input.
PC
Searching...
[Searching...] is displayed during the input search.
■
[Input search]: [Custom]
[1st search input], [2nd search input]
Set the input to search when [Custom] is selected.
[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]
/ [ DVI-D ] / [SLOT] / [PC] / [USB] / [(None)]
■
[Input search]: [Input detection]
Input search
Input search
HDMI1
DVI-D
Changing delay
HDMI2
Input detection
Off
Off
Off
Off
PC Off
DisplayPort Off
DIGITAL LINK Off
Sets the input to monitor during [Input detection].
[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]
/ [ DVI-D ] / [PC]
[Off]: The input is not monitored.
[On]: The input is monitored.
■
[Changing delay]
Sets the delay time until the input is switched during
[Input detection].
[Off]: Switches the input if a signal is interrupted
even for a very short period.
1 ‒ 10: Sets the delay time (sec.).
Switches the input when the set time has
elapsed after detecting no signal is present.
However, if the detection period during
which no signal is present is shorter than the
set delay time, the input is not switched.
Note
● [Input detection] is the function that automatically
switches the input as below by monitoring the
presence of signal for the set input.
• If a video signal is input to the set input that is
not displayed (When the status has changed
from signal absent to signal present.), the input is
selected and switched.
• If no signal is detected for the displayed input, the
setting switches to the set input to which a signal is
input. Also, if no signal is present for the displayed
input when the power is turned on or when the
input is switched, the setting switches to the set
input to which a signal is input. When signals are
input to multiple set inputs, the priority order as
default (immediately after power-on) is as follows:
HDMI1, HDMI2, DisplayPort, DIGITAL LINK,
DVI-D, PC.
In the other case (When the input is switched after
power-on), the input displayed last takes priority.
● [Changing delay] is the function to prevent the
accidental input switch during a short period, such as
when the signal is interrupted due to the frequency
change for the input signal while [Input detection] is
operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
● [Input detection] may not operate correctly depending
on the image playback device.