MITSUBISHI ELECTRIC MR-J2S- CP - Manual (Page 35)

1 - 16
1. FUNCTIONS AND CONFIGURATION
(2) MR-J2S-200CP MR-J2S-350CP
POINT
This servo amplifier is shown without the front cover. For removal of the
front cover, refer to section 1.6.2.
MODE UP DOWN SET
Cooling fan
Fixed part (4 places)
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
Reference
Section4.5
Chapter7
Name/Application
Battery holder
Contains the battery for absolute position data backup.
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
MODE UP DOWN SET
I/O signal connector (CN1A)
Used to connect digital I/O signals.
Communication connector (CN3)
Used to connect a command device (RS-422/RS-232C)
and output analog monitor data.
Name plate
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Main circuit terminal block (TE1)
Used to connect the input power supply and servo
motor.
Protective earth (PE) terminal ( )
Ground terminal.
Section4.5
Operation section
Used to perform status display, diagnostic, alarm,
parameter and point table setting operations.
Chapter7
Section3.3
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Section3.3
Chapter6
Chapter15
Section14.1.4
Section1.4
Section3.3
Section14.1.4
Control circuit terminal block (TE2)
Used to connect the control circuit power supply and
regenerative option.
Section3.7.2
Section12.1
Section3.7.2
Section12.1
Section14.1.1
Section3.10