Kawasaki STX-15F - Manual (Page 190)

6-12 ENGINE TOP END
Cylinder Head Cover
Cylinder Head Cover Removal
•
Remove:
Air Suction Valve Hoses [A]
Spark Plug Caps [B]
Breather Hoses [C]
•
Remove the cylinder head cover bolts [A] and take off the
cover [B].
Cylinder Head Cover Installation
•
Be sure to install the pins [A] and rubber gaskets [B].
•
Replace the head cover gasket with a new one if dam-
aged.
•
Apply silicone sealant [A] to the cylinder head cover gas-
ket as shown.
Sealant - Kawasaki Bond (Silicone Sealant): 56019-120
•
Install the washer with the metal side [A] faces upward.
•
Tighten:
Torque - Cylinder Head Cover Bolts [B]: 9.8 N·m (1.0 kgf·m,
87 in·lb)
•
Route the hoses correctly (see Appendix chapter).