Kawasaki STX-15F - Manual (Page 93)

FUEL SYSTEM (DFI) 3-39
Water Temperature Sensor (Service Code/Character-14/AqUt)
Water Temperature Sensor Removal/Installation
CAUTION
Never drop the sensor, especially on a hard surface.
Such a shock to the sensor can damage it.
•
Disconnect the sensor connector [A], and unscrew the
water temperature sensor [B].
•
When installing the water temperature sensor, remove the
exhaust manifold for the engine oil filling in the hollow of
the exhaust manifold.
•
Fill the hollow of the exhaust manifold [A] with the engine
oil (10W-30) [B] as shown, before installing the water tem-
perature sensor [C].
[D] 5 mm (0.2 in.)
•
Tighten:
Torque - Water Temperature Sensor: 15 N·m (1.5 kgf·m, 11
ft·lb)
Output Voltage Inspection
NOTE
○
Be sure the battery is fully charged.
•
Remove the ECU (see ECU Removal). Do not disconnect
the connector.