Kawasaki STX-15F - Manual (Page 314)

13-8 HULL/ENGINE HOOD
Fittings
•
Drill out the rivets [A] with a drill bit [B] of the correct size
and remove the front duct cover [C].
Rivet Removal Drill Bit Size
5.0 mm (0.2 in.)
NOTE
○
Stop drilling when the rivet head starts to turn with drill
bit.
○
Tap the rivet out with a suitable punch and hammer.
Front Storage Compartment Cover Assembly
•
Secure the front duct cover to the front duct [A] with the
rivets using a riveter [B].
•
Be sure that the trim seals [A] are in position.
•
Torque the lock assembly nut.
Torque - Lock Assembly Nut: 4.9 N·m (0.50 kgf·m, 43 in·lb)
•
Apply a non-permanent locking agent to the following
bolts.
Air Duct Bolts
Hinge Bolts
Damper Bolts