Kawasaki STX-15F - Manual (Page 229)

ENGINE BOTTOM END 8-9
Coupling
•
Using the rotor holder [A], remove the output shaft [B].
Special Tool - Rotor Holder: 57001-1544
Coupling/Output Shaft Installation
•
Apply molybdenum disulfide oil solution to the seating sur-
face of the output shaft.
•
Using the rotor holder [A], install the output shaft [B].
Special Tool - Rotor Holder: 57001-1544
Torque - Output Shaft: 245 N·m (25.0 kgf·m, 180 ft·lb)
•
Apply silicone sealant [A] to the crankcase halves mating
surfaces on the magneto cover.
•
Be sure to install the dowel pins [B].
•
Apply grease to the O-ring [A], and fit the O-ring onto the
groove of the magneto cover [B].
•
Install the magneto cover.
○
Be sure to install the washer [C] and the spring [D] into
the hole [E] of the bushing.
Torque - Magneto Cover Bolts: 20 N·m (2.0 kgf·m, 14 ft·lb)
•
Apply grease to the O-ring [A] and collar inside.
•
Install the collar [B] so that the chamfer side [C] faces
inward.