Kawasaki STX-15F - Manual (Page 193)

ENGINE TOP END 6-15
Camshaft, Camshaft Chain
Camshaft Installation
•
Be sure to install the following parts.
Pins [A]
•
Apply molybdenum disulfide oil solution to all cam parts
and journals.
NOTE
○
The exhaust camshaft has a 320 EX mark [A] and the
inlet camshaft has a 320 IN mark [B]. Be careful not to
mix up these shafts.
If the camshaft position sensor rotor is removed, install it
as follows.
○
Insert the pin [A] into the holes [B] in the camshaft and
boss [C].
○
Fit the projection [A] of the rotor [B] on the camshaft re-
cess [C].
○
Apply a non-permanent locking agent to the camshaft po-
sition sensor rotor bolt [D], and tighten it.
Torque - Camshaft Position Sensor Rotor Bolt: 12 N·m (1.2
kgf·m, 104 in·lb)
•
Remove:
Coupling Cover Bolts [A]
Clamps [B]
Coupling Cover [C]