Kawasaki STX-15F - Manual (Page 233)

ENGINE BOTTOM END 8-13
Magneto Flywheel
•
Apply grease to the boss outside [A] of the magneto fly-
wheel [B].
10 mm (0.39 in.) [C]
•
Install the magneto flywheel.
NOTE
○
Confirm the magneto flywheel fit or not to the crankshaft
before tightening it with specified torque.
○
Install the output shaft and tighten it with 70 N·m (7.0
kgf·m, 52 ft·lb) of torque.
○
Remove the output shaft.
○
Check the tightening torque with rotor puller.
Special Tool - Rotor Puller: 57001-1623
Grip: 57001-1591
If the magneto flywheel is not pulled out with 20 N·m (2.0
kgf·m, 52 ft·lb) of drawing torque, it is installed correctly.
If the magneto flywheel is pulled out with under 20 N·m
(2.0 kgf·m, 52 ft·lb) of drawing torque, clean off any oil dirt
or flaw of the crankshaft and magneto flywheel tapered
portion, and dry them with a clean cloth. Then, confirm
that it is not pulled out with above torque.
•
Tighten the output shaft while holding the magneto fly-
wheel steady with the rotor holder.
Special Tool - Rotor Holder: 57001-1544
Torque - Output Shaft: 245 N·m (25 kgf·m, 180 ft·lb)
•
Install:
Magneto Cover (see Coupling/Output Shaft Installation)