Kawasaki STX-15F - Manual (Page 375)

ELECTRICAL SYSTEM 14-49
Kawasaki Smart Steering System
Steering Position Sensor and Magnet Removal
•
Remove the steering holder (see Steering Removal in
Steering chapter).
•
Remove or disconnect:
Steering Position Sensor Lead Connector [A]
Leads Clamp on Steering Holder
Steering Position Sensor Mounting Screws [B]
Steering Position Sensor [C]
•
Unscrew the mounting screw [A] and remove the magnet
[B].
Steering Position Sensor and Magnet Installation
•
Moving the steering shaft in the direction [A] and [B],
check the steering shaft for excessive play.
If necessary, adjust the steering shaft nut or replace the
bushings.
•
Apply a non-permanent locking agent to the steering
position sensor mounting screws and magnet mounting
screw.
•
Install the steering position sensor [A] to the steering
holder and align the projection [B] on the magnet with the
hole [C] on the steering shaft plate.