Parker Hannifin Dynaserv G2 - Manual (Page 114)

8-22
DrvGII PC Utility
8
8.5.2 Jog Move
Click “Jog (J)” in the “DriveMenu” dialog box to display the “JogMove” dialog box (see Figure 8.22). If the
connection with the driver is established, the current values of the related parameters are read and can be edited.
Figure 8.22 “JogMove” dialog box
(1) Editing parameters
1) Click the parameter value cell of the parameter to be changed. The current value is displayed in the changed
value text field.
2) Enter a value in the changed value text field and click the Enter (Return) key or click another cell to make the
new parameter value valid.
3) Repeat steps 1) and 2) as necessary and click “Set (S)” to set the changed values in the driver. If there is an
error in the set value, a warning message is displayed and the parameter is read again. Parameters whose
setting values are erroneous will not be changed; therefore the changed parameters should be verified.
Parameter number
cell
Changed value text
field
Parameter content
cell
Parameter value cell