Roland RD-700 - Manual (Page 105)

105
Effect/Parameter List
Appendices
04: PHASER
A phaser adds a phase-shifted sound to the direct sound,
producing a twisting modulation that creates spaciousness and
depth.
Manual #
Adjust the basic frequency from which the sound will be
modulated.
Rate #
Adjust the frequency (period) of modulation.
Depth
Adjust the depth of modulation.
Resonance
Adjust the amount of feedback for the phaser.
The effect becomes more prominent as the value is increased.
Mix (Mix Level)
Adjust the ratio with which the phase-shifted sound is
combined with the direct sound.
Pan (Output Pan)
Adjust the stereo location of the output sound. L64 is far left, 0
is center, and 63R is far right.
Level (Output Level)
Adjust the output level.
05: SPECTRUM
Spectrum is a type of filter which modifies the timbre by
boosting or cutting the level at specific frequencies. It is similar
to an equalizer, but has 8 frequency points fixed at locations
most suitable for adding character to the sound.
Band 1 (Band 1 Gain)
Adjust the 250 Hz gain.
Band 2 (Band 2 Gain)
Adjust the 500 Hz gain.
Band 3 (Band 3 Gain)
Adjust the 1000 Hz gain.
Band 4 (Band 4 Gain)
Adjust the 1250 Hz gain.
Band 5 (Band 5 Gain)
Adjust the 2000 Hz gain.
Band 6 (Band 6 Gain)
Adjust the 3150 Hz gain.
Band 7 (Band 7 Gain)
Adjust the 4000 Hz gain.
Band 8 (Band 8 Gain)
Adjust the 8000 Hz gain.
Q
Simultaneously adjust the width of the adjusted areas for all the
frequency bands.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left, 0
is center, and 63R is far right.
Level (Output Level) #
Adjust the output level.
06: ENHANCER
The Enhancer controls the overtone structure of the high
frequencies, adding sparkle and tightness to the sound.
Sens (Sensitivity) #
Adjust the sensitivity of the enhancer.
Mix (Mix Level) #
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Low Gain
Adjust the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low frequency
range.
High Gain
Adjust the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high frequency
range.
Level (Output Level)
Adjust the output level.
07: AUTO WAH
The Auto Wah cyclically controls a filter to create cyclic change
in timbre.
Filter (Filter Type)
Select the type of filter.
LPF : The wah effect will be applied over a wide frequency
range.
BPF : The wah effect will be applied over a narrow frequency
range.
Sens (Sensitivity)
Adjust the sensitivity with which the filter is controlled.
Manual #
Adjust the frequency from which the effect is applied.
Peak
Adjust the amount of the wah effect that will occur in the area
of the frequency. Lower settings will cause the effect to be
applied in a broad area around the frequency. Higher settings
will cause the effect to be applied in a more narrow range.
Rate #
Adjust the frequency of the modulation.
Depth
Adjust the depth of the modulation.
Level (Output Level)
Adjust the output level.
RD-700_e.book 105 ページ ２００３年１０月２３日 木曜日 午後４時５９分