Roland RD-700 - Manual (Page 42)

42
Performing with the Keyboard
Performing
Playing with Two Layered Tones ([LAYER])
fig.panel
1
Press [LAYER], getting the indicator to light.
PART SWITCH [UPPER1] and [UPPER2] are lit.
Try fingering the keyboard.
fig.LCD
The Tones for UPPER1 and UPPER2 are layered and played.
2
To exit Layer mode, press [LAYER] once more, and the
indicator light goes out.
CONTROL
1,2
Pressing Two TONE SELECT buttons Simultaneously (Layer Mode)
* Keep [NUM LOCK] off when carrying out this operation.
You can switch to Layer mode without pressing the [LAYER] button simply
by pressing two TONE SELECT buttons at the same time.
For example, if you want to layer a piano sound with strings, together press
both [PIANO] and [STRINGS].
The [LAYER] indicator automatically lights up, and when you begin
playing the keyboard, the piano and strings sounds are layered together.
When this is done, the tone for the button that is pressed down first
(indicator lit in red) is assigned to UPPER1, and the other tone (indicator lit
in orange) is assigned to UPPER2. The UP1 and UP2 Part names are both
highlighted in the screen, with both Parts being selected.
When two TONE SELECT buttons are selected, then pressing any TONE
SELECT button selects the Tone for that button, and the RD-700 reverts to
Single mode.
* The procedure described above does not switch the RD-700 to Layer mode when [LOWER] is
selected in the PART SELECT buttons.
RD-700_e.book 42 ページ ２００３年１０月２３日 木曜日 午後４時５９分