Roland RD-700 - Manual (Page 63)

63
Using the RD-700 As a Master Keyboard
Master Keyboard
Detailed Settings for
Transmitted Parts ([MIDI TX])
After pressing [MIDI TX], you can then set the following
parameters affecting MIDI TX parts.
fig.LCD
How to Make Settings
1. Press [MIDI TX], getting the indicator to light.
The RD-700 is set to control the external MIDI devices.
2. Press CURSOR [ ], [ ], [ ], or [ ] to move the
cursor to the parameter to be set.
You can get the cursor to move more rapidly by holding
down the CURSOR button that points in the direction
you want the cursor to move while you also press the
CURSOR button that points in the opposite direction.
3. Press [INC/YES] or [DEC/NO] to set the value.
Press [INC/YES] and [DEC/NO] simultaneously to
switch the Value to “--- (OFF).”
Adjusting the Volume and Pan
Sets the panning (localizes sound image) for each of the
Tones.
The Volume setting is mainly used in the Split and Layer key
modes to obtain the desired balance in volume between each
part.
The Pan setting positions the sound image of each part when
the output is in stereo. With an increase in the value for L,
more of the sound will be heard as coming from the left side.
Similarly, more of the sound will originate at the right if the
value of R is increased. When set to 0, the sound is heard as
coming from the center.
Setting the Amount of Reverb and
Chorus
This sets the depth of the reverb and chorus effects.
Setting the Key Range (LWR/UPR)
Set the keyboard range in which each Part will sound.
This can be used to make notes in different areas of the
keyboard play different Tones.
Specify the lower limit (LWR) and upper limit (UPR) of the
key range being set.
NOTE
This is effective only when [SPLIT] is on (p. 43) in the key
range settings.
NOTE
You cannot set the key range’s lower limit higher than the
upper limit, nor can you set the upper limit below the lower
limit.
You can use PART SWITCH for each individual part to select
whether or not MIDI Note messages for that part are to be
Parameter TX CC# Value
VOL (Volume) CC07 0-127
PAN (Pan) CC10 L63–0–63R
Parameter TX CC# Value
REV (Reverb) CC93 0–127
CHO (Chorus) CC91 0–127
Parameter Value
LWR (Lower) A0–C8
UPR (Upper) A0–C8
Using the RD-700
As a Master
Keyboard
RD-700_e.book 63 ページ ２００３年１０月２３日 木曜日 午後４時５９分