Roland RD-700 - Manual (Page 66)

66
Piano Edit
Making Detailed Settings for the Piano Tones
(Piano Edit)
You can make more detailed settings to fashion just the
Tones you want using the piano Tone selected by pressing
ONE TOUCH [PIANO] (p. 35).
This function is called “Piano Edit.”
The settings made in Piano Edit are stored to ONE TOUCH
[PIANO].
NOTE
When ONE TOUCH [PIANO] is pressed, all settings other
than the Piano Edit settings are switched to their status at the
time the RD-700’s power was turned on.
Store any arrangements of settings that you want to keep in
Setup (p. 56).
Making the settings
1. While holding down ONE TOUCH [PIANO], press
[SETUP].
[EDIT] and [NUM LOCK] are lit, and the following
Piano Edit screen appears.
fig.04-01
2. Press CURSOR [ ] or [ ] to switch screens, and press
CURSOR [ ] or [ ] to move the cursor to the
parameter to be set.
3. Press [INC/YES] or [DEC/NO] to set the value.
4. When you finish making settings, press ONE TOUCH
[PIANO].
Parameters
Selecting the Piano Sound
This chooses the piano Tone to be selected when ONE
TOUCH [PIANO] is pressed.
There are sixteen Tones to choose from.
Changing the Width of the Sound
(Stereo Width)
Adjusts the spaciousness of the sound.
Changing the Sound’s Nuance
(Nuance)
This changes the Tone’s subtle nuances by altering the phase
of the left and right sounds.
NOTE
Depending on the piano Tone selected, this setting may not
be available.
NOTE
This effect is difficult to hear when headphones are used.
Parameter Value Description
Stereo Width 0–63
Changes the width of the
sound. The higher the
value set, the wider the
sound is spread out.
Parameter Value
Nuance OFF, TYPE1, 2, 3
RD-700_e.book 66 ページ ２００３年１０月２３日 木曜日 午後４時５９分