Roland RD-700 - Manual (Page 70)

70
Detailed Settings for Each Function ([EDIT])
Edit Mode
Adjusting the Volume
(Master Volume)
Adjusts the volume of the entire RD-700.
Preventing Equalizer Settings
from Being Switched (EQ Control)
You can store different equalizer settings (p. 74) for each
individual Setup (p. 54).
This setting determines whether or not the Setup equalizer
settings values are to be changed when Setups are switched.
When this is set to SYSTEM, a “ ” is displayed in the
upper right of each screen.
NOTE
With this setting set to SYSTEM, you cannot change the
Control/EQ settings (p. 74).
Retaining the Current Tone Even
When Tones Are Switched (Tone
Remain)
This setting specifies whether the currently heard sound will
continue (ON) or not (OFF) when another tone is selected.
NOTE
Effects settings change as soon as you switch to a new Tone,
without being influenced by the Tone Remain setting.
Because of this, certain effects settings can cause notes that
were until then sounding to no longer be heard, even though
Tone Remain has been set to on.
Changing the Clock (Timing)
Source (Clock Source)
You can control the tempo from an external MIDI device. Set
this to MIDI when synchronizing to the clock (tempo) of an
external MIDI device.
Internal tempo settings are made in the Tone screen (p. 32),
the Rhythm Edit screen (p. 82), and the Arpeggio Edit Screen
(p. 83).
NOTE
The tempo cannot be set if Clock Source is set to MIDI
without there being any external MIDI device connected.
This can result in arpeggios (p. 49) and Rhythms (p. 51) not
sounding, and may change the manner in which certain
effects are applied.
Switching Between Reception of
GM/GM2 System On and GS
Reset
Specifies whether General MIDI System On, General MIDI 2
System On, or GS Reset messages from external MIDI
devices will be received (ON) or not (OFF).
Using Program Change
Messages to Switch Setups
(Control Channel)
You can switch the RD-700’s Setups with MIDI messages
from an external MIDI device.
Set the MIDI Receive channel for receiving the MIDI
messages (Program Changes) from the external MIDI device
to be used for switching Setups.
When not switching Setups from an external MIDI device, set
this to OFF.
Parameter Value
Master Volume 0–127
Parameter Value Description
EQ
Control
SETUP
Equalizer settings change when
Setups are switched.
SYSTEM
Equalizer settings do not change
when Setups are switched.
Parameter Value
Tone Remain OFF, ON
Parameter Value Description
Clock
Source
INT Synchronized to the internal clock
MIDI
Synchronized to the external
MIDI device’s clock
The tempo indication “ ”
changes to “M:” for each screen.
Parameter Value
Rx GM System ON
ON, OFF Rx GM2 System ON
Rx GS Reset
RD-700_e.book 70 ページ ２００３年１０月２３日 木曜日 午後４時５９分