Roland RD-700 - Manual (Page 78)

78
Detailed Settings for Each Function ([EDIT])
Edit Mode
Making Reverb Settings
Reverb adds the reverberation characteristics of halls or
auditoriums. Four different types are offered, so you can
select and use the type that suits your purpose.
You can set the amount of reverb applied separately for each
individual part (p. 80).
Reverb Type
When you change the Reverb Type, the Reverb parameters
will be automatically adjusted to the optimal values. Rather
than setting the reverb parameters one by one, you can make
the settings more easily by first setting the Reverb Type and
then changing only the necessary parameters.
Some Reverb Type settings have parameters that cannot be
set. Parameters that cannot be changed are indicated by “—
—–.”
Reverb Pre-Delay
Adjust the time delay from when the direct sound begins
until the reverb sound is heard.
The delay time increases as the value is raised.
Values: 0.0–100.0
Reverb Time
Adjust the time length of reverberation.
The reverberation becomes longer as the value is increased.
Values: 0–127
Reverb High Cut Frequency
This sets the frequency above which the high-frequency
content of the reverb will be reduced. If you do not wish to
cut the high range of the returned sound, select BYPASS.
Values: 160, 200, 250, 320, 400, 500, 640, 800, 1000, 1250, 1600,
2000, 2500, 3200, 4000, 5000, 6400, 8000, 10000, 12500,
BYPASS
<Other Prm>, Value
You can make more detailed reverb settings.
When Other Prm is selected, the indication of the
corresponding Value changes, and the value is set.
Refer to “REVERB” (p. 134).
Setting Chorus and Delay
Chorus adds depth and spaciousness to the sound. You can
select whether to use this as a chorus effect or a delay effect.
You can set the amount of chorus applied separately for each
Tone (p. 80).
Chorus/Delay
You can select whether to use this as a chorus effect or a
delay effect.
Values: Chorus, Delay
When Chorus/Delay is Set to Chorus
Chorus Pre-Delay
Specifies the delay time from the original sound until when
the chorus sound is heard.
The delay time increases as the value is raised.
Values: 0.0–100.0
Chorus Rate
Specifies the modulation frequency of the chorus sound.
The interval between undulations is shortened as this value
is increased.
Values: 0.05–10.00
Parameter Value Description
Reverb
Type
OFF Reverb is not used.
REVERB Normal Reverb
SRV ROOM
Simulates the reverbera-
tion of room interiors. It
produces a well-defined
and spacious reverbera-
tion.
SRV HALL
Simulates the reverbera-
tion exhibited by hall. It
provides a deeper rever-
beration than the Room
reverbs.
SRV PLATE
Simulates a plate reverb
unit (a type of artificial re-
verb that utilized a metal
plate).
RD-700_e.book 78 ページ ２００３年１０月２３日 木曜日 午後４時５９分