Roland RD-700 - Manual (Page 18)

18
Getting Ready
Getting Ready
Checking the Installed Wave Expansion Boards
After installation of the Wave Expansion Boards has been completed, check
to confirm that the installed boards are being recognized correctly.
fig.panel
1
Turn on the power, as described in “Turning On the Power”
(p. 24).
2
Hold down EXPANSION [A] or [B] for several seconds.
The name of the installed wave expansion board appears in the display.
fig.LCD
The example here depicts what you would see if the SRX-02 “Concert
Piano” Wave Expansion Board were installed in the SRX A slot.
By releasing the button, you go back to the previous screen.
CONTROL
2
NOTE
If “—————-” appears
next to the name of the slot
in which the board was
installed, it may be that the
wave expansion board is
not being recognized
properly. Use the
procedure in “Turning Off
the Power”
(p. 25) to turn
the power off, then reinstall
the wave expansion board
correctly.
For instructions on
selecting Wave Expansion
Board Tones, refer to
“Selecting Wave
Expansion Board Tones”
RD-700_e.book 18 ページ ２００３年１０月２３日 木曜日 午後４時５９分