Roland RD-700 - Manual (Page 125)

125
Effect/Parameter List
Appendices
Pkg Freq
This sets the reference frequency for the filter used in adjusting
the specific range of frequencies.
When not cutting bass frequencies, set this to BYPASS.
Pkg Q
The range of frequencies is based on the frequency set in Pkg
Freq.
The smaller the value, the narrower the band of frequencies that
is adjusted with Pkg Gain.
Pkg Gain
This sets the gain (boost or cut) of the range of frequencies set in
Pkg Freq and Pkg Q.
LF Damp
This sets the reference frequency used in cutting the resonance
sound's low-end component.
When not cutting these sounds, set this to BYPASS.
HF Damp
This sets the reference frequency used in cutting the resonance
sound's high-end component.
When not cutting these sounds, set this to BYPASS.
Diffusion
Adjusts the change in the density of the resonance over time.
65: OD → ROTARY (Overdrive → Rotary)
This effect connects an overdrive and a rotary in series.
Drive
Adjust the degree of distortion. The volume will change
together with the degree of distortion.
OD OutLvl (Overdrive Level)
Sets the Overdrive output level.
OD Sw (Overdrive Switch)
Switches the Overdrive on and off.
Low Slow (Low Frequency Slow Rate)
Adjust the slow speed (SLOW) of the low frequency rotor.
Low Fast (Low Frequency Fast Rate)
Adjust the fast speed (FAST) of the low frequency rotor.
Low Accel (Low Frequency Acceleration)
Adjust the time it takes the low frequency rotor to reach the
newly selected speed when switching from fast to slow (or slow
to fast) speed. Lower values will require longer times.
Low Level (Low Frequency Level)
Adjust the volume of the low frequency rotor.
Hi Slow (High Frequency Slow Rate)
Adjust the slow speed (SLOW) of the high frequency rotor.
Hi Fast (High Frequency Fast Rate)
Adjust the fast speed (FAST) of the high frequency rotor.
Hi Accel (High Frequency Acceleration)
Adjust the time it takes the high frequency rotor to reach the
newly selected speed when switching from fast to slow (or slow
to fast) speed. Lower values will require longer times.
Hi Level (High Frequency Level)
Adjust the volume of the high frequency rotor.
Separate (Separation)
Adjust the spatial dispersion of the sound.
Speed #
Simultaneously switch the rotational speed of the low
frequency rotor and high frequency rotor.
SLOW : Slow down the rotation to the specified speed (the Low
Slow/Hi Slow values).
FAST : Speed up the rotation to the specified speed (the Low
Fast/Hi Fast values).
Level (Output Level) #
Adjust the output level.
When Using 3D Effects
The following three 3D effects utilize RSS (Roland Sound
Space) technology to create a spaciousness that cannot be
produced by delay, reverb, chorus, etc.
48: 3D DELAY
60: 3D CHORUS
61: 3D FLANGER
When using these effects, we recommend that you place
your speakers as follows. Also, make sure that the speakers
are at a sufficient distance from the walls on either side.
fig.RSS
If the left and right speakers are too far apart, or if there is
too much reverberation, the full 3D effect may not appear.
Each of these effects has an Out (Output Mode) parameter.
If the sound from the OUTPUT jacks is to be heard through
speakers, set this parameter to SPEAKER. If the sound is to
be heard through headphones, set it to PHONES. This will
ensure that the optimal 3D effect will be heard. If this
parameter is not set correctly, the full 3D effect may not
appear.
30˚ 30˚
RD-700_e.book 125 ページ ２００３年１０月２３日 木曜日 午後４時５９分