Roland RD-700 - Manual (Page 53)

53
Using the Convenient Functions in Performances
Convenient Functions
Applying Effects to the Sound
(MULTI EFFECTS)
In addition to chorus (p. 47) and reverb (p. 47), the RD-700 also allows you
to apply “multi-effects” to sounds. Multi-effects provides a collection of 65
different effects, such as distortion and rotary, from which you can choose.
The factory settings have a suitable effect assigned to each of the tones.
fig.panel
1
Press MULTI EFFECTS [ON/OFF], getting its indicator to
light.
2
Adjust the amount of multi-effect applied with the
[CONTROL] knob.
3
To cancel the multi-effect, press MULTI EFFECTS [ON/OFF],
the indicator light goes out.
For further details on the
onboard effects, see the
“Effect/Parameter List”
(p. 104).
CONTROL
1,2,3
NOTE
Effects are not applied to
Tones for which the Tone
Edit MFX settings in Edit
mode are set to “00
THROUGH” (p. 80). In that
case, the MULTI EFFECTS
[ON/OFF] indicator will
blink.
The allowable values
adjusted with the
[CONTROL] knob vary
with the selected effect. For
details, refer to “MFX
Control”
(p. 77).
When Using Multi-effects in Split or Layer Mode
The RD-700 cannot use more than one multi-effect at a time. Therefore, there
is a “Source” parameter for whatever multi-effects settings you select, and a
“Dest.” parameter for the part to which those settings are to be applied.
Thus, you should note that depending on the Source or Dest. settings, some
Parts may not have multi-effects applied while in Split or Layer mode.
For more detailed information, refer to “MFX Source, MFX Dest” (p. 77).
You can change the multi-effects type as well as a variety of other multi-
effects settings. For details, refer to “Making Multi-Effects Settings” (p. 77).
RD-700_e.book 53 ページ ２００３年１０月２３日 木曜日 午後４時５９分