Roland RD-700 - Manual (Page 36)

36
Performing with the Keyboard
Performing
Performing with a Variety of Tones
The RD-700 provides 468 types of Tones.
Each one of these individual sounds is called a tone.
Tones are assigned to the TONE SELECT buttons according to the tone
category selected.
Try selecting and performing with a number of different tones.
fig.panel
1
Press ONE TOUCH [PIANO].
This selects a single tone to be played over the entire keyboard.
2
Press any of the TONE SELECT buttons to select the tone
category.
3
Press [INC/YES] or [DEC/NO] to select the tone.
The TONE SELECT button for the selected category flashes.
4
Either press the flashing TONE SELECT button or play the
keyboard.
The TONE SELECT button stops flashing and remains lit, and the selected
tone is set.
Play the keyboard, and you will hear the selected tone.
The next time you choose this TONE SELECT button, the tone you’re
selected here is played.
For more on the RD-700’s
internal tones, refer to the
“Tone List”
(p. 135).
CONTROL
1 3 2,4
When changing tones in
Layer mode (p. 42) or Split
mode (p. 43), select the part
for which the tone is to be
changed with the PART
SELECT buttons, without
pressing the ONE TOUCH
[PIANO] button. For
details, refer to “Changing
Tones in Layer and Split
Mode” (p. 44).
NOTE
If [NUM LOCK] is turned
on, the Tone Category
cannot be selected with
TONE SELECT button.
For details, refer to p. 37.
NOTE
Tones selected with [RHY/
GM2] are registered in the
following order: “Rhythm
Sets,” “GM2 Rhythm Sets,”
and “GM2 Tones.” Refer to
the “Tone List” (p. 135).
RD-700_e.book 36 ページ ２００３年１０月２３日 木曜日 午後４時５９分