Technicolor - Thomson ST585 V6 - Manual (Page 126)

E-DOC-CTC-20061027-0004 v1.0
CWMP Commands
102
cwmp config
Configure the cwmpd as seen from the ACS.
SYNTAX:
where:
cwmp config [state = <{disabled|enabled}>]
[mode = <{readonly|full}>]
[periodicInform = <{disabled|enabled}>]
[periodicInfInt = <number>]
[sessionTimeout = <number>]
[noIpTimeout = <number>]
[maxEnvelopes = <number>]
[connectionRequest = <{disabled|enabled}>]
[connectionReqPath = <string>]
[connectionReqUserName = <string>]
[connectionReqPsswd = <string>]
[connectionReqAuth = <{none|basic|digest}>]
[qos-class = <number>]
[bootdelayrange = <number>]
state The state of the cwmp daemon.
Choose between:
>
enabled
>
disabled.
The default is disabled .
OPTIONAL
mode Set the operation mode of the cwmp daemon.
Choose between:
>
readonly
> full.
The default is readonly .
OPTIONAL
periodicInform Set the periodicInform flag of the cwmp daemon.
Choose between:
> enabled
> disabled.
The default is enabled .
OPTIONAL
periodicInfInt A number (of seconds).
Represents the interval between two periodicInform
messages.
The default is
3600 .
OPTIONAL
sessionTimeout Set HTTP session-timeout in seconds.
The default is
60 .
OPTIONAL
noIpTimeout Set time (in seconds) ip may be 0 after uploading new
config file.
The default is
10 .
OPTIONAL