Technicolor - Thomson ST585 V6 - Manual (Page 333)

E-DOC-CTC-20061027-0004 v1.0
Eth Commands
309
eth switch mirror egress
Enable or disable the specified port to be the Mirror Egress Port.
SYNTAX:
where:
EXAMPLE:
Here port 1 is enabled as Mirror Egress Port
Here port 1 is disabled as Mirror Egress Port
RELATED COMMANDS:
i Only one port can be the Mirror Egress Port at any one time.
But a port can be the Mirror Egress Port and the
Mirror Ingress Port at the same time.
eth switch mirror egress port = <number{1-4}>
[state = <{enabled | disabled}>]
port The port to be the Mirror Egress Port.
Note If no port number is specified, then the port number of
the current Mirror Egress Port is shown.
REQUIRED
state Enable or disable the port as Mirror Egress Port.
The default is
enabled .
OPTIONAL
=>eth switch mirror egress port=1
=>eth switch mirror egress
Egress mirror port = 1
=>
=>eth switch mirror egress
Egress mirror port = 1
=>eth switch mirror egress port=1 state=disabled
=>eth switch mirror egress
=>
eth switch mirror capture Define the specified port to be the Mirror Capture Port.
eth switch mirror ingress Enable or disable the specified port to be the Mirror Ingress Port.