Technicolor - Thomson ST585 V6 - Manual (Page 757)

E-DOC-CTC-20061027-0004 v1.0
Wireless Commands
733
wireless ifconfig
Configure the wireless settings.
SYNTAX:
where:
wireless ifconfig [state = <{enabled | disabled}>]
[channel =
<{auto | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10
| 11 | 12 | 13}>]
[ssid = <quoted string>]
[any = <{disabled | enabled}>]
[interop = <{802.11b | 802.11b/g | 802.11g}>]
[frameburst = <{disabled | enabled}>]
state Enable or disable the interface operational status of wireless access
point.
The default is
enabled .
OPTIONAL
channel The communication channel number.
Choose between:
> auto : the best communication channel is automatically selected by
the Thomson ST (recommended setting).
>
a number between 1 and 14.
Note Depending on local regulations, the number of channels
actually allowed to be used, may be restricted.
The default is auto .
OPTIONAL
ssid The network name, also known as Service Set ID (SSID). OPTIONAL
any Make the SSID public or not.
Choose between:
> enabled : the Thomson ST broadcasts its SSID and accepts every
client.
> disabled : the Thomson ST does not broadcast its SSID and accepts
only those clients who have the correct SSID.
The default is enabled .
OPTIONAL
interop Select the interoperability mode.
Choose between:
> 802.11b : only IEEE 802.11b clients can connect to the Thomson ST.
> 802.11b/g : IEEE 802.11g and b clients can connect to the
Thomson ST.
Note When a IEEE 802.11b client connects to the Thomson ST,
the modulation rate drops to 11Mbps for this client.
>
802.11g : only IEEE 802.11g clients can connect to the Thomson ST.
The default is 802.11b/g .
OPTIONAL
frameburst Enable or disable framebursting.
The default is
disabled .
OPTIONAL