Technicolor - Thomson ST585 V6 - Manual (Page 494)

E-DOC-CTC-20061027-0004 v1.0
IPQoS Commands
470
ipqos config
Configure IPQoS for a given destination interface for the IPQoS queues instantiation.
SYNTAX:
where:
i When enabling or disabling IPQoS, take the following into account:
>
if the WAN interface (for example PPPoA, IP oA,...) is detached at the time of enabling/disabling
IPQoS, then the WAN interface has to be attached in order for the enabling/disabling of IPQoS to
take effect.
> if the WAN interface is attached at the time of enabling/disabling IPQoS, then the WAN interface
has to be detached and then re-attached in order for the enabling/disabling of IPQoS to take
effect.
ipqos config dest = <string>
[state = <{disabled | enabled}>]
[discard = <{tail | early}>]
[priority = <{wfq | strict | wrr}>]
[realtimerate = <number{1-100}>]
[burstsize = <number{1-128}>]
[weight1 = <number{1-97}>]
[weight2 = <number{1-97}>]
[weight3 = <number{1-97}>]
[weight4 = <number{1-97}>]
[maxpackets = <number{0-100}>]
[maxbytes = <number{0-128}>]
dest The destination interface for the IPQoS queues instantiation.
This is an ATM phonebook entry. REQUIRED
state Disable or enable IPQoS for the interface.
The default is
disabled .
OPTIONAL
discard Determines the packet discard strategy in case of congestion.
Choose between:
> tail : Tail Drop: arriving packets will be dropped as soon as the
destination queue is in an overflow state.
>
early : Early Packet discard: arriving packets will be dropped early
according to the BLUE active queue management algorithm.
The default is early .
OPTIONAL