Technicolor - Thomson ST585 V6 - Manual (Page 256)

E-DOC-CTC-20061027-0004 v1.0
DynDNS Commands
232
dyndns modify
Modify a dynamic DNS client.
SYNTAX:
where:
dyndns modify name = <string>
[intf = <string>]
[user = <string>]
[password = <password>]
[group = <string>]
[mx = <string>]
[backmx = <{disabled | enabled}>]
[wildcard = <{disabled | enabled}>]
[offline = <{disabled | enabled}>]
[service = <{dyndns | statdns | custom | No-IP |
DtDNS
| gnudip}>]
[status = <{disabled | enabled}>]
[trace = <{disabled | enabled}>]
name The name of the dynamic DNS client to be modified. REQUIRED
intf The dynamic DNS client interface.
Note This parameter must be defined to enable the dynamic DNS
client.
OPTIONAL
user The username for dynamic DNS authentication. OPTIONAL
password The password for dynamic DNS authentication. OPTIONAL
group The dynamic DNS host group. OPTIONAL
mx The mail exchanger. OPTIONAL
backmx Set up the mail exchanger as a backup mail exchanger (enabled) or
not (disabled).
The default is
disabled .
OPTIONAL
wildcard Allow the use of hostname wildcards (enabled) or not (disabled).
The default is
disabled .
OPTIONAL
offline Set the host to offline mode (enabled) or not (disabled).
The default is
disabled .
OPTIONAL
service The dynamic DNS service. Choose between:
> dyndns
> statdns
> custom
> No-IP
> DtDNS
> gnudip.
OPTIONAL