Technicolor - Thomson ST585 V6 - Manual (Page 275)

E-DOC-CTC-20061027-0004 v1.0
Eth Commands
251
14 Eth Commands
Introduction
This chapter describes the commands of the eth command group.
Contents
This chapter covers the following commands:
eth ifadd Create a new ETH interface. 253
eth ifattach Attach an ETH interface. 254
eth ifconfig Modify an ETH interface. 255
eth ifdelete Delete an ETH interface. 256
eth ifdetach Detach an ETH interface. 257
eth iflist Display the ETH interfaces. 258
eth flush Flush all the ETH interfaces. 259
eth bridge clear Clear the bridge statistics. 260
eth bridge list Display the current bridge instances. 261
eth bridge add Add a new bridge instance. 262
eth bridge delete Delete a bridge instance. 263
eth bridge select Select the default bridge to configure interfaces . 264
eth bridge config Modify/display the bridge configuration settings. 265
eth bridge dynvlan actlist Display the active MAC entries for the dynamic VLAN
membership. 266
eth bridge dynvlan add Add a dynamic VLAN membership entry. 267
eth bridge dynvlan config Modify the dynamic VLAN membership configuration. 268
eth bridge dynvlan delete Delete a dynamic VLAN membership entry. 269
eth bridge dynvlan flush Flush all dynamic VLAN membership entries. 270
eth bridge dynvlan list Delete a dynamic VLAN membership entry. 269
eth bridge flush Flush bridge interfaces and parameters. 272
eth bridge ifadd Add a new bridge interface. 273
eth bridge ifattach Attach a bridge interface. 274
eth bridge ifconfig Modify a bridge interface configuration. 275
eth bridge ifdelete Delete a bridge interface. 277
eth bridge ifdetach Detach a bridge interface. 278
eth bridge iflist Display the current bridge interfaces. 279
eth bridge ifflush Flush the bridge interfaces 280
eth bridge igmpsnooping config Configure the bridge instance‘s IGMP Snooping flags 281
eth bridge igmpsnooping list Display a bridge instance‘s snooped groups 282
eth bridge igmpsnooping ifconfig Configure the bridge interface‘s IGMP snooping flags
and mode 283